How to Measure Windows for Replacement

After a few months of pondering whether you should remove the old windows and buy new replacement windows, you have finally made up your mind. However, replacing windows is more than just removing the existing windows and installing new units. You should understand how to measure such windows, especially when shopping the windows on your own. Here we are going to provide you with in-depth insights into measuring windows.

Generally, the most important thing is understanding how to measure full-frame installation windows. But if you think this is more complicated for you, then it makes sense to hire a professional to do it for you. Installing replacement units is a fantastic experience but a complex one as well. Though we tend to support DIY projects, their success depends on knowing what you can do and what you should leave to professionals. Incorrectly installed units can lead to many problems, such as structural damage due to water damage. They might also not serve the purpose of why they were installed. We don’t want you to be the victim of poorly installed windows. Here are the steps for measuring replacement windows.

The Tools You Need

When planning to measure your replacement windows, you require some tools to make this happen. For some people, you might have these tools in their garage, but if you don’t have them, you will need to go to the nearest local tool shop and purchase them.

  • Measuring tape
  • Level
  • Notepad
  • Pencil

All these tools are important though some might appear very basic.

Step One: Collect the Tools You Need and Do Your Research

For instance, if you want to take measurements for full-frame window replacement, you should understand what you are looking for. You should go to YouTube and collect all the available guides and ensure you are ready and know what to do. Generally, it is recommended that if you don’t have the necessary experience in window replacement, it is best to leave this work to an expert. This is because measuring replacement windows is difficult, although you might correct the mistakes. But don’t forget all that will increase the cost of replacing your windows. However, if you have all the tools you need and are sure this is something you can pull off, let’s go to the next step.

Step Two: Measuring the Height

This is where you should start. To measure the height, start at the head, which is the top of the window, to the window sill point. Make sure that you locate all the points. Repeat the process several times, then put the smallest measurement in your notebook. Take it and reduce it by an eighth of an inch. The resulting number is the actual length of your window.

Step 3: Measuring the Width

One challenge people face while trying to measure the width of the window replacement is finding an ideal spot to measure the window. Generally, to measure the width of your window replacement Oakville, you should lift the sash to ensure that the measurements are correct.

To take this measurement, you should measure between the window jambs surface on both sides of the frame. Like you did when measuring the length, you should repeat this several times, note down the smallest number, and deduct an eighth inch. What you get is the final measurement of your window. For convenience, you can sketch a diagram to record your measurements. 

Step 4: Measuring Depth

If this is the first time you are measuring window replacement in Oakville, you might find it challenging to measure the depth of the window. You need to take the correct depth measurements since they determine whether the window will fit snuggly with the frame.

To take the measurements, measure between the outside and inside stops to ensure the depth is accurate. The digit you get should be at least 3 ¼ inches; if you get something different from this, your measurements could be off. Ensure you measure multiple times to ensure that the figure you get is consistent since any discrepancy could cost you a lot of money.